Hey guys I'm planning to add a bi-xenon projector to the highbeam side of my waja headlamp... I'll be using h1 bulbs. I need advice and info on how do I rewire for the projectors to act as a low beam and high beam.. I was recommended a wire harness but it's for the H4 bi xenon bulbs. so do I modify the harness for my H1 bulbs? Thanks in advance.

4566 views

10 Dec

Proton
495 followers

Comments

Johan Kamarudin

You need to separate the lens from the casing. Either use a hot gun or bake in an oven. Only then you can install either bixenon hid or better choice bi-led projector.

11 Dec

Azrulein Ibrahim

After market bi-xenon usually comes with wiring required. The main component is actually the ballast. Bi-xenon requires higher volt make electrical jump, and ultimately create a spark that will light up the xenon gas inside the bulb. Therefore, the ballast is actually to increase the voltage from 12V (car) up to 24,000V insider the bulb so that it can creates the jump. Contrary to halogen bulb, create light by heating up the filamen in the bulb.

11 Dec

Jack hu

just leave it to the workshop guy lah🤣

11 Dec

william ng

newbie driver here, what does the bi-xenon projector work for?🤔

11 Dec

Home > Hey guys I'm planning to add a bi-xenon projector to the highbeam side of my waja headlamp... I'll be using h1 bulbs. I need advice and info on how do I rewire for the projectors to act as a low beam and high beam.. I was recommended a wire harness but it's for the H4 bi xenon bulbs. so do I modify the harness for my H1 bulbs? Thanks in advance.

Tools

Comments

Hot Topic